13
CHANGING THE OIL, CLEANING OIL FILTER SCREEN
1. of the engine and let the oil drain into an approved collection container.
DO NOT PERFORM THIS PROCEDURE WHILE THE ENGINE IS HOT.
SERIOUS BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures, contact your local oil recycling
center.
3. Clean oil screen and spring with solvent.
4. Clean and replace the oil drain plug making sure it is secure.
oil in the engine by using the oil gauge plug and/or sight gauge.
CHECK-UP OF SPARK PLUG
1. Remove the cap of spark plug and screw off the spark plug using the plug wrench.
2. Clean the spark plug all around or replace it if it is corroded or there is too much deposit on it.
3. Regulate the gap of the spark plug to 0.6-0.8mm. (.024 inches - .032 inches)
The spark plug of the designated type should be used. The applicable type of spark plug: D8RTC
(Torch) or equivalent
To Next Page
Loading...