EasyManua.ls Logo

PPS Viper 150-E - Troubleshooting; Fuel Supplying Check

PPS Viper 150-E
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
TROUBLESHOOTING
This troubleshooting guide is provided to help you to find the cause of some common complaints.
COMPLAINT: Engine is hard to start or does not start at all. Something is probably wrong with
the fuel system or ignition system.
CAUTION
Failing to troubleshoot a problem correctly would damage your Dirt Bike.
Improper repairs or adjustments may damage the vehicle. Such damage may not be covered
under warranty. If you are not sure about the proper action, consult your authorized service
center or Ricky Power Sports LLC. about the problem.
FUEL SUPPLYING CHECK
1. Make sure there is adequate fuel in the fuel tank.
2. Check that the engine stop switch is in the RUN position.
3. Check that the fuel valve is in the “ON” position.
4. Make sure there is enough fuel reaching the carburetor from the fuel tank.
WARNING
Draining fuel from the carburetor could be hazardous.
Fuel could catch fire if you do not handle it properly.
When draining the carburetor, be sure to shut the engine off. Do not smoke, and never drain or
refuel in an area where there are open flames or sparks. Do not spill the fuel or you may create a
fire hazard. Dispose of drained fuel properly.
a. Loosen the drain screw which is located under the carburetor. Drain the fuel from the
carburetor into a container.
b. Tighten the drain screw.
c. Run the engine for a few seconds. Shut off engine.
d. Loosen the drain screw and check that the carburetor is filled back up with fuel.
e. If fuel is reaching the carburetor, the ignition system should be checked Next.