PR electronics 9106 - Help Text Overview; Parameter and Function Explanations

20 9106 - Product version 9106-002
Help text overview
[01]
[02]
[03]
[04]
[05]
[06]
[09]
[10]
[11]
[12]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
Set correct password [PASS]
Enter advanced setup [ADV.SET]
Set low limit for loop error detection [LO.LIM1] [LO.LIM2]
Set high limit for loop error detection [HI.LIM1] [HI.LIM2]
Enable rail status signal output? [RAIL.ER]
Enter display setup [SETUP]
Enter password setup [SETUP]
Enter language setup [SETUP]
Enter rail setup [SETUP]
Adjust LCD contrast [CONTRA]
Adjust LCD backlight [LIGHT]
Write a 5-character tag no. [TAGNO1] [TAGNO2]
Show loop values in display
Show Tag no. in display
Alternate shown information in display
Enable password protection [EN.PASS]
Set new password [NEW.PAS]
Select language [LANGUA]
Loop signal limit exceeded
Loop wire breakage
No communication - check connections
Eeprom error - check configuration
Hardware error