PR Lighting PR-2203 XR 200 - STAND-ALONE MODE; MASTER;SLAVE MODE; OPERATION MENU

7/20
Press button ENTER to confirm; after powered next time, It will display latest values.
Press button FUNC, it will return to the upper menu one by one.
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the
projector will run in Stand-Alone mode automatically.
MASTER/SLAVE MODE
Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them
with each other. Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the
second fixture’s input and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX
terminator as shown in the figure below. Then the first one is the master with setting options as master mode
enabled, and others are slaves.
Start Address for all slaves is 001. The Master can run at any mode for the Master and Slaves run at the
corresponding mode compared to the Master.
After powered , the group will run at Master/Slave Mode.
.
OPERATION MENU
1st LEVEL 2nd LEVEL 3rd LEVEL 4th LEVEL
AddR
XX
X
(
1~512
)
CNFG
(Config Settings)
dmX
(DMX Mode
,Default: STD)
S
Td
(
DMX Mode Standard
)
S
HR
T
(
DMX Mode Shor
t
)
LA-C
(Lamp Control
,Default: CHAN)
CHAN
(By Control Channel)
P
O
WE
(
B
y
Power
)
xyCH
(Pan Tilt Swap,
Default: OFF)
O
F
F
O
N
xyCP
(Pan Tilt Invert,
Default: OFF)
O
F
F
O
N
mOR
S
(Master/Slave Options,
Default: SLAV
)
SLAV
(Slave)
mAST
(Master 1)
INPUT
OUTPUT
MASTER
SLAVE
SLAVE
INPUT
OUTPUT
INPUT
DMXTERMINATOR