■ 6 Determining moisture levels
50
6.3 Setting drying parameters
The drying parameter setting procedure is started with the four
function keys under the display.
Each of the four function keys starts the entry of the corresponding
drying parameter. The parameters are entered or changed in the same
way as the menu operation procedure (see chapter 5.1 "Menu control
operation principle"), except that only the current parameter can be
changed each time.
6.3.1 Heating program
This function key is used to start the heating program selection.
There are three heating programs available for determining the
moisture content:
• Standard drying
• Boost drying
• Soft drying
NOTE
The additional solvent is taken into account in the measurement
printout because all the interim values are calculated on the basis of
the current weight value.
However, it has no bearing on the drying result because the solvent
has completely dried off.
To Next Page
Loading...
