Precisa XM 60 - Ash Residue with New Tare Weight

■ 7 Ash residue program
62
If "MEMORY CHOICE OFF", the process will run for only one sample.
Selection of the initial sample weight number and re-zero are not nes-
seccary.
7.2.2 Ash residue with new tare weight
If the dry mass is transferred into a new tare vessel, or if samples are
to be used which have not been dried, "MODE MANUAL" or "MODE
AUTO" should be used.
Display Key Step
+ 0.000 9
«D»
Change to residual
ORIGINAL
+ 0,000 9
«E»
Confirm the choice
RESIDUaL
+ 0.000 9
«T»
Tare the device without load
Tare
+ 0.235 9 Put the pan with the ash onto
the balance
RESIDUaL 0.000 9
+ 4.52 %
«E»
Confirm the weighing
Ash residue
The ash residue is automatically calcultated and printed.
Display Key Step
«START»
Keep the key pressed until
"ASH RESIDUE" is displayed.
Release the key.
- - - - - - -
A»,
«B»
Select the weighing number1
(resp. 2-4)
-1- -2- -3- -4-
+ 0,000 9
«E»
Confirm the choice
original