905E, 9.1, 9.10 Treadmills
Page 10
Procedure 2.6 - Placing the 905e, 9.1 and 9.10 Treadmills in
Power Bit Mode
Procedure
1. Place the magnetic safety key in the ACTIVATE position, then turn on the treadmill with the
circuit breaker.
2. With the Enter Your Weight banner scrolling, press and hold the SPEED ▲ key, SPEED ▼
key, STOP and SCAN/ENTER keys simultaneously.
3. Watch the electronic console. When the potentiometer increment number is displayed on
the electronic console, enter power bit mode by pressing the SPEED ▼ key.
Note:
When you remove your finger from the SPEED ▼ key, the number of power bits will be displayed.
Power bits are directly related to the drive motor input signal. The power bit number represents a
combination of requested speed and actual load.
To Next Page
Loading...
