Precor 905e - Procedure 2.3 - Selecting United States Standard or Metric Units

905E, 9.1, 9.10 Treadmills
Page 7
Procedure 2.3 - Selecting United States Standard or Metric
Units
Selecting United States standard units causes information to be displayed in feet and pounds.
Information is displayed in meters and kilograms if metric units are selected. After you have
selected a measurement standard, the software compiles and records workout information in the
units of the measurement standard selected. Changing to the alternate measurement standard
after your workout has started will cause invalid data to be displayed. For this reason, change the
measurement standard only after turning ON the treadmill.
Procedure
The measurement standard must be changed within five seconds of turning on the treadmill.
1. Place the magnetic safety key in the ACTIVATE position, then turn on the treadmill with the
circuit breaker.
2. With the Enter Your Weight banner scrolling, press and hold the SPEED ▲ and SCAN/
ENTER keys simultaneously until the Press ▲ for MPH & miles or ▼ for KPH &
kilometers message scrolls across the screen.
3. Use the SPEED ▲ or SPEED ▼ key to select the measurement standard.
Note:
When the treadmill is turned off or unplugged it will remember the last measurement standard
selected.