905E, 9.1, 9.10 Treadmills
Page 32
13. Slide the connector and ribbon cable through the slot on the upper handrail clamp. Hold the
potentiometer cable away from the slot as you slide the ribbon cable into place.
14. Hold the electronic console over the lift column. Connect the ribbon cable to the upper PCA.
15. Position the electronic console on the upper handrail clamp. Replace the bolts and washers
that secure the electronic console to the upper handrail clamp.
16. Position the crank handle at its mounting position and use the 1/8” allen wrench to tighten
the set screws that secure the crank handle to the top of the lift jack.
17. Using the cable ties, secure the ribbon cable to the cable tie mounts on the lift column.
Note:
Refer to Diagram 6.7 when you perform the next step.
Diagram 6.7 - Attaching the Lift Column Trim to the Lift Column
To Next Page
Loading...
