905E, 9.1, 9.10 Treadmills
Page 35
12. Inspect and adjust the target gap as described in Procedure 3.4 of the Residential Treadmill
Service Manual.
13. Tighten the bolts and nuts that secure the lower PCA to the motor chassis.
14. Attach the ribbon cable to the lower PCA.
15. Connect the wires listed in Table 9.1-3 to the lower PCA.
16. Remove the ground lead of the wrist strap from the treadmill frame, then remove the wrist
strap from your arm.
17. Replace the hood as described in Procedure 5.1 of the Residential Treadmill Service
Manual.
18. Check the operation of the treadmill as described in Section Three of this appendix.
To Next Page
Loading...
