C776i Stairclimber
Page 22
Diagram 6.2 - Upper and Lower Data Cables, Mid-Point
Troubleshooting the Mid-Point Connector
8. Remove the upper and lower data cables from the mid-point connector.
9. Connect the upper and lower data cables to a known good mid-point connector.
10. If the C776i now functions correctly, replace the mid-point connector. If the C776i still
functions incorrectly, replace the original mid-point connector. The problem may be caused
by another component such as the upper printed circuit assembly or the lower printed circuit
assembly. Troubleshoot those component per the appropriate troubleshooting procedure.
11. If all of the above test have been performed and the C776i is still not functioning correctly,
call Precor technical. support.
Upper Data Cable
Lower Data Cable
Mid-Point
Connector
Lower Printed
Circuit Assembly
To Next Page
Loading...
