C776i Stairclimber
Page 52
Procedure 7.16 - Replacing a Stairarm
1. Remove the stairarm foot plate per Procedure 7.15, steps 1-3.
2. Remove the retaining clip and the black plastic washer from the stairarm being replaced.
See Diagram 7.12.
Diagram 7.12 - Stairarms
3. Remove the stairarm. If the lower stairarm is being replaced, remove the bumper from the
stairarm and mount it on the replacement stairarm.
4. The upper and lower stairarms are the same part. Therefore, the upper stairarm will also
have bumper mounting holes. If the upper stairarm is being replaced, orient the stairarm so
that the bumper mounting holes are facing downward.
5. Verify that the black plastic spacer is on the stairarm mounting shaft and slide the
replacement stairarm onto the stairarm mounting shaft.
6. Fasten the stairarm with the black plastic washer and retaining clip removed in step 2.
7. Replace the foot plate and belt per Procedure 7.15, steps 5-9.
Bumper
Stairarm
& Retaining Clip
Plastic Spacer
Plastic Washer
To Next Page
Loading...
