C776i Stairclimber
Page 49
Procedure 7.14 - Replacing the Right or Left Handlebar
1. Loosen but do not remove the two handlebar clamp nuts. See Diagram 7.8.
2. Remove the bolt retaining the frame end cap. Remove the frame endcap and slide the
handlebar boot up to expose the handlebar mounting bolt, See Diagram 7.10
Diagram 7.10 - Lower Handlebar Mounting
3. Remove the handlebar mounting bolt.
4. Slide the upper end of the handlebar out the handlebar clamp and lift the handlebar from its
lower rear mount.
5. Remove the handlebar boot from the handlebar and install it on the replacement handlebar.
6. Set the replacement handlebar on its lower rear mount and slide the upper end of the
handlebar into the handlebar clamp.
7. Verify that both the left and right handlebar are fully inserted in the handlebar clamp and
tighten both handlebar clamp nuts.
8. Fasten the lower rear handlebar with the bolt removed in step 3.
9. Slide the handlebar boot down into position and replace the endcap with the bolt removed in
step 2.
Endcap
Mounting
Bolt
Handlebar
Boot
Mounting
Bolt
To Next Page
Loading...
