C776i Stairclimber
Page 53
Procedure 7.17 - Replacing a Generator
1. Remove the left hand cover per Procedure 7.1.
2. Attach the wrist strap to your arm, then connect the ground lead of the wrist strap to the
climber frame.
3. Disconnect all of the wiring from the lower printed circuit assembly See Diagram 7.13.
Diagram 7.13 - Generator Mounting
4. Remove the four screws that retain the lower printed circuit assembly. Remove the lower
printed circuit assembly and set it on a static safe surface.
5. Remove the four screws that fasten the lower printed circuit assembly mounting plate to the
generator. See Diagram 7.14
Diagram 7.14 - Lower Printed Circuit Assembly Mounting Plate
Lower Printed
Circuit Assembly
Generator
Mounting
Plate
Mounting
Screw
To Next Page
Loading...
