C776i Stairclimber
Page 8
4. The message SOFTWARE VERSION will be displayed for two seconds and then UPPER
APP XXXX-XXX. Press
T or S key to toggle display between the upper boot software
version, lower software version and the upper app. software version. Press the ENTER key
to continue to the error log.
5. The message ERROR LOG will be displayed followed by the error in log position 1. Each
log entry shows the log position, the floor count when the error occurred and the hour meter
when the error occurred. For example; 1 ER05 123456 FLR 45678 HRS. The error log
can record up to ten error conditions. The error code in position one will be the most recent
error and the error in position ten will be the oldest error. If more than ten errors have been
logged, only the ten most recent will be displayed. When a new error is logged, the oldest
error will be deleted from the log. Use the
T and S keys to move through the log. Pressing
and holding the QUICK START key for four seconds will clear the log. Press the ENTER key
to advance to the serial number display.
6. The message SERIAL NUMBER will be displayed for two seconds and the serial number
will be displayed. Press the ENTER or RESET key to exit.
To Next Page
Loading...
