Product Owner’s Manual: Club Features 16
Choosing a Language
The unit can display user prompts, text, and user entries in seven
different languages. When the unit is shipped from the factory it is set
to display English.
Note: Programming prompts are not affected by language selection.
The prompts in this section continue to appear in English.
4. At the SELECT LANGUAGE prompt, press OK. Use the up or
down arrow keys to choose between ENGLISH, ESPANOL,
FRANCAIS, DEUTSCH, NEDERLANDS, PORTUGUES, and
RUCCKIJJ.
5. When you are ready, press OK to accept the displayed setting and
move to the next program. Or, press PAUSE/RESET to return to
the Precor banner.
Selecting a U.S. Standard or
Metric Display
The unit can display measurements in either Metric or U.S. Standard.
The default factory setting is set to display U.S. Standard. To change
this setting, perform the following steps:
6. At the SELECT UNITS prompt, press OK. Use an arrow key to
select a unit of measure (U.S. or METRIC).
CAUTION: If you change the Unit of Measure display, be sure
to check the speed setting on the treadmill to verify that it is
correct. Refer to Treadmill: Determining the Club Speed Limit.
7. When you are ready, press OK to accept the displayed setting and
move to the next program. Or, press PAUSE/RESET to return to
the Precor banner.
To Next Page
Loading...
Need help?
General
