Product Owner’s Manual: Club Features 15
Accessing Club Programs and Settings
Read the Club Programming Tips to identify which keys let you save
changes and to learn how to use the navigational keypad in the middle
of the display: BACK, Up/Down arrow keys, and OK.
To access the available menus and change the program settings,
perform the following steps:
1. At the Precor banner, press the following keys in sequence
without pausing between selections:
PAUSE/RESET, 5, 6, 5, 1, 5, 6, 5
Selecting Safety Code Protection
When the unit is shipped from the factory, the safety code protection
feature is disabled. If you enable the safety code, your patrons will
need to enter four number keys in sequence to begin their exercise
session and, on the treadmill, start the running belt. If the correct keys
are not pressed within two minutes, further access is denied. For more
information, refer to Treadmill: Entering the Safety Code.
2. At the SAFETY CODE prompt, press OK. Use an arrow key to
alternate between the two selections.
CAUTION: Do not assume the unit is safe because of safety
code protection. Never leave children unsupervised around
the unit.
3. When you are ready, press OK to accept the displayed setting and
move to the next program. Or, press PAUSE/RESET to return to
the Precor banner.
Setting Description
ENABLED Causes the safety code prompt to appear prior to a
workout and when returning from pause mode.
DISABLED Does not require a safety code to operate.