Product Owner’s Manual: Club Features 23
Informational Displays
The unit provides information about its use (odometer and hour
meter), as well as software version, serial number, usage log, and error
log. In general, you would only access this information if directed to do
so by Precor Customer Support.
These instructions guide you through all the informational displays.
Pressing the ENTER key moves you through the displays. To exit,
press the PAUSE/RESET key at any time.
Important: Quick access to the informational displays is available
if error messages have appeared on the display and have been
recorded in the error log. This feature is usually reserved for service
personnel. At the Precor banner, press and hold PAUSE/RESET for
4 seconds. If DIAGS - INFORMATION DISPLAY appears continue
with step 2. If no errors are logged, STOP KEY appears. When you
release the key, the Precor banner returns.
Note: On treadmills, the red STOP button can be used instead of the
PAUSE /RESET key.
Viewing the Odometer
1. At the Precor banner, press the following keys in sequence and
without pause:
PAUSE /RESET, 6, 5
DIAGS - INFORMATION DISPLAY appears briefly and is
replaced by ODOMETER, which scrolls continuously.
2. When you are ready to view the odometer value, press OK.
Note: The odometer value correlates to the type of Precor
product and the standard of units, U.S. or Metric, selected in the
club programs. Refer to Table 5.
Table 5. Odometer displays and values.
3. To move to the next display (hour meter), press BACK and then
press the ▼ arrow key on the navigational bar.
Viewing the Hour Meter
HOUR METER appears on the display and scrolls continuously.
4. When you are ready, press OK to see the number of hours that the
unit has been in use. The unit tracks the elapsed minutes, but the
value that appears is truncated to the nearest full hour.
5. To move to the next display (software versions), press BACK and
then press the ▼ arrow key on the navigational bar.
Unit
Odometer
Display Odometer Value
Treadmill miles or
kilometers
number of cumulative miles (MILES) or
kilometers (KM) logged to date.
EFX strides number of total strides logged to date.
Cycle revolutions number of total revolutions logged to date.
Climber floors number of cumulative floors. Steps are
converted to floors based on an 8-inch
(20cm) step and a 10-foot (approximately
3 meter) floor. Each floor is equal to 15
steps.
To Next Page
Loading...
Need help?
General
