Product Owner’s Manual: Club Features 13
Club Programming Tips
• Always start at the Precor banner.
• Electrical power must be supplied. For self-powered units, a
constant power source is available if you use the optional power
adapter, otherwise you will have to maintain the minimum power
requirements. Refer to Self-Powered Features. If you plan to
program a self-powered unit, purchasing the optional power adapter
is highly recommended.
Note: If you do not use the optional power adapter during club
programming mode, and the pedal or stepping speed falls below
the minimum requirement, no warning is given when the unit
moves into its 30-second shutdown procedure.
• The club programming mode is accessed by pressing the PAUSE/
RESET key at the Precor banner. The remaining key presses must
occur quickly and without pause.
Note: Keys that can be used interchangeably in club programming
mode are:
OK and ENTER
PAUSE/RESET and the red STOP button (treadmill only)
• The club programming prompts appear sequentially and in a menu
format. Pressing the ▼ or ▲ arrow keys in the navigational bar
moves you through the programs. Press OK to choose or accept
the displayed selection. To return to the previous menu level without
saving any changes, press BACK.
Note: The number keypad is disabled once you enter club
programming mode.
To Next Page
Loading...
