C960 Series Commercial Treadmill
Page 23
12. Loosen the socket head bolts and washers that secure the switch bracket to the lift platform
(see Diagram 4.2).
Note:
The zero sense switch can be actuated if the center of the wheel is slightly above or slightly
below the widest point of the switch actuator. However, for best results, adjust the position of the
zero sense switch as described in the following step.
13. If the center of the wheel on the zero sense switch is above the widest point of the switch
actuator...
THEN... OTHERWISE...
Move the switch bracket down until Move the switch bracket up until the
the widest part of the actuator is widest part of the actuator is centered
centered on the wheel on the zero on the wheel on the zero sense switch;
sense switch; then continue with then continue with the next step.
the next step.
14. Tighten the socket head bolts and washers that secure the switch bracket to the lift platform.
15. Replace the hood
16. Check the operation of the treadmill as described in Section 3 of this appendix.
IMPORTANT
If the electronic console displays the diagnostic message LIFT ERROR PRESS STOP when you
incline or decline the running bed to its maximum limits, repeat this procedure.
To Next Page
Loading...
Need help?
General
