Precor C966i Owner's Manual

page 33
COMMERCIAL PRODUCTS DIVISION
Once the C996i is set up, it is ready to use. There are no complex instructions to
follow or mandatory programming steps required to operate the treadmill. The easy-
to-understand prompts let you select a program and specify how long you want to
work out. Begin working out and then, adapt the speed and incline level to meet
your fitness goals.
CAUTION: Before beginning any fitness program, have your physician give
you a complete physical examination.
USING THE SECURITY CLIP
A security clip is attached by its cord to the red STOP button that straddles the
handrail. Always attach the security clip to your clothing before each work-
out. A tug on the cord trips the security switch and slows the running belt to a
stop. If the security switch trips while you are working out, the treadmill retains
your workout statistics and enters Pause mode. To resume your workout,
re-attach the security clip to your clothing, and press the SPEED ▲ key until you
reach the desired speed.
Important: Club owners, managers, personal trainers. Remind users how impor-
tant it is to use the security clip while working out on the treadmill. Instruct them on
how to attach it to their clothing near their waistline. If any complications occur, a
strong tug on the security cord will stop the running belt.
Note: A velcro patch is located on the right side of the console by the handrail.
Use it to store the clip while the treadmill is not being used.
PAUSE, COOL DOWN, SUMMARY AND EXIT FEATURES
Pausing, cooling down, and exiting are integral parts of your workout and can be
accessed any time during a program. The treadmill goes through several prereq-
uisites before actually exiting a program. The following tables explain the different
conditions or situations that apply.
In a program,
you press This is what happens...,
STOP Enter pause mode. The running belt slows to a gradual stop.
Note that you may also press the SPEED ▼ key until zero
appears on the display. Once the running belt stops, TIME
stops accruing. The display features remain, so you can
review your workout statistics. The factory setting for pause
mode is 2 minutes (120 seconds). The club has the option to
change the setting. A duration can be set between 1 and 120
seconds and limits how long a user can pause his or her
workout. Refer to Club Information on page 21.
Exercising on the Treadmill

Precor C966i Specifications

Power and Motor

motor power	4.0 hp continuous duty
power requirements 120v	120 v @ 50/60Hz 20 Amps
power requirements 240v	240v @ 50/60Hz 20 Amps

Performance

speed range	0.5 to 16 mph (1 to 26 kph)
incline range	-3% to 15% grade

Weight and Dimensions

length	86 inches (218 cm)
width with handrails	37 inches (93 cm)
width without handrails	34 inches (86 cm)
height	59 inches (150 cm)
weight	375 lbs (170 kg)
shipping weight	470 lbs (213 kg)
running surface	60 inches x 20 inches (153 cm x 51 cm)