5.33 Ellipitical Fitness Crosstrainer
Page 10
Procedure 2.3 - Accessing the Set User Parameters Display
Selecting United States standard units causes information to be displayed in miles. Information is
displayed in kilometers if metric units are selected. After you select a measurement standard, the
software accumulates and records workout information in the units of the measurement standard
selected.
Procedure
1. Plug the power cord into the wall outlet, then turn on the EFX 5.33 with the on/off switch.
2. With the PRECOR EFX 5.33 banner displayed, press keys RESET,5,6,7,1, sequentially.
3. The display name “SELECT UNITS” will be displayed for 2 seconds.
4. One of two measurement standards will be displayed, U. S. Standard or Metric.
5. If U. S. Standard is selected, weights will be in pounds and distances will be in miles. If
Metric is selected, weights will be in kilograms and distances in kilometers.
6. If you wish to change the measurement standard...
THEN... OTHERWISE...
Use the
or keys to toggle Continue with the next step.
to an alternate measurement standard;
then continue with the next step.
7. Press the ENTER key to save the currently displayed selection and exit the set user
parameters display or press the RESET key to leave the selection unchanged and exit the
set user parameters display.
To Next Page
Loading...
