Precor EFX 5.33 - Procedure 7.30 - Replacing Handlebar to Stairarm Link; Handlebar to Stairarm Link Replacement

5.33 Ellipitical Fitness Crosstrainer
Page 88
Procedure 7.30 - Replacing the Handlebar to Stairarm Link
(serial code AAAB, only)
Procedure
1. Set the on/off switch in the off position. Remove the A.C. line cord from the A.C. outlet and
from the power entry module.
2. Remove the end caps from the rear and the front inside of the handlebar to stairarm link.
See Diagram 7.33.
Diagram 7.33 - Handlebar to Stairarm Link (serial code AAAB)
3. Remove the mounting bolt washer and spacer from the front inside and rear of the
handlebar to stairarm link. Remove and discard the handlebar to stairarm link.
4. Slide one of the spacers, removed in step 3 into the front of the replacement handlebar to
stairarm link. Set the replacement handlebar to stairarm link at its mounting position to the
handlebar. Hand start, but do not tighten the mounting bolt with washer.
5. Slide one of the spacers, removed in step 3 into the rear of the replacement handlebar to
stairarm link. Set the replacement handlebar to stairarm link at its mounting position to the
stairarm. Hand start, but do not tighten the mounting bolt with washer.
Front, Inside
Rear
End Cap
Mounting Bolt
Mounting Bolt