Precor EFX 5.33 - Axle to Axle Measurement and Alignment

5.33 Elliptical Fitness Crosstrainer
Page 21
Diagram 5.6 - Pillow block Mounting Bolts
6. Using a rubber mallet, gently tap the top of the pillow block with two loosened nuts (the right
hand pillow block in our illustration) until the two measurements in Diagram 5.6 are within
1/16 inch.
7. Torque the three loose pillow block mounting nuts to 80 inch pounds.
Input Drive Axle to Step Up Pulley Axle Alignment
8. Mark the current position of the step up pulley on both side of the drive weldment.
9. On both sides of the drive weldment measure the distance from the input drive axle to the
step up pulley axle. See Diagram 5.7.
Diagram 5.7 - Axle to Axle Measurement
Loosen
Loosen
Loosen
Do not Loosen
Tap Here
Measurement
Step Up Pulley Axle
Input Drive Axle
Adjustment Nut