User’s Reference Manual: Display Console 12
Keypad
Use the keypad to enter your workout session selections.
Note: The EFX534i has a stationary ramp. The RESISTANCE keys
replace the CROSSRAMP keys shown in this diagram.
SELECT: The SELECT keys have two functions:
• To get specific information during a workout. Each SELECT
key affects the column above it. Indicator lights appear next
to the item that is displayed.
• To activate scanning mode and select the information that
appears. Refer to Changing the Display Features Using the
SELECT Key.
RESET: While exercising or during pause mode, press the
RESET key to end your session and display a workout
summary. Press RESET again to return to the Precor banner.
No workout statistics are saved.
Important: The optional power adapter must be connected to
pause longer than 30 seconds during a workout.
QUICKSTART: Press QUICKSTART to bypass the setup
prompts and start your workout immediately using the Manual
Program. Refer to Choosing QUICKSTART.
ENTER: Use the ENTER key to enter responses to workout-
specific prompts.
RESISTANCE ▼▲: Press and hold the RESISTANCE arrow
keys to increase or decrease the force applied against your
stride from 1 to 20.
During your workout, to view the current resistance, tap either
RESISTANCE ▼ or ▲ key. To change the resistance, press
the arrow key for more than one second.
CROSSRAMP ▲▼ (EFX524i): Press and hold the
CROSSRAMP arrows to increase or decrease the ramp
incline from 1 to 20.
Changes to the ramp incline are not immediate. It takes time
for the lift to reach the target incline shown on the display.
Important: Ramp changes occur only when the foot pedals
are in motion. The number that appears on the display
indicates the selected range, not the degree of incline. There
is not a one-to-one relationship between the degree of incline
and the CrossRamp setting.
EFX524i
To Next Page
Loading...
