Precor FTS Glide User Manual

FTS Glide Assembly and Maintenance Guide
page 19
1 2 3 4 5 6
4
Adjustments and
Maintenance
Adjustments and Maintenance
When the FTS Glide is completely assembled, you
need to check the cables for proper tension. Obvious
signs that cable problems exist include:
✔ Top Weight Assembly does not rest squarely on the
top weight of the Weight Stack.
✔ Cable rubs the inside edges of the pulleys.
✔ Excess slack exists in the cable.
✔ Weight Pin cannot be easily inserted in or removed
from each hole in the Weight Stack.
✔ Selector Stem rubs inside the Weight Stack.
CAUTION: Take the time to perform the following
steps. If the cables do not have the proper tension
you could void the Precor Limited Warranty.
If you experience any of these cable problems, remove
the Weight Pin from the Weight Stack to ensure the
least cable resistance and then make the proper cable
adjustments.
Top Weight
Assembly
Weight pin
A slack cable
Pulley
Weight Stack
Holes in Weight Stack

Precor FTS Glide Specifications

Weight and Dimensions

length	48.5 inches (123 cm)
height	85 inches (216 cm)
width	53 inches (135 cm)