Precor FTS Glide User Manual

FTS Glide Assembly and Maintenance Guide
page 21
3. Maintenance
Guide Rods
A Apply one tube of lubricant to each Guide Rod.
B. Lubricate the Guide Rods every six months.
CAUTION: The lubricant can stain clothes. Wear
proper attire when lubricating the Guide Rods.
Lubricant
Guide Rod
Adjustments and Maintenance, continued
Inspection
Inspect the unit daily.
Look and listen for frayed or worn parts, loose
fasteners, cable tensions issues, unusual noises, and
any other indications that the equipment may be in need
of service.
You are responsible for the proper maintenance of the
unit as discussed in this manual. For other service
issues, contact Customer Support. Refer to Obtaining
Service.
Shrouds
CAUTION: Clean the Shrouds with product
specifically labeled as safe for acrylic. Use a clean,
nonabrasive cloth and light pressure to avoid
scratching the acrylic surface.
The acrylic Shrouds on the FTS Glide are easily
scratched or damaged through improper cleaning
techniques. To avoid problems, dust the shrouds often
with a clean, lint-free cloth and light pressure. Avoid
rubbing dirt or grit into the surface. If you use glass
cleaner or a similar product, make sure the label states
that it is safe to use on Plexiglas
®
or acrylic products.
Important: DO NOT use ketones, aromatics, esters,
halogens, window cleaning sprays, alcohol, kitchen
scouring compounds, or solvents (such as acetone,
benzene, gasoline, carbon tetrachloride, or thinners).
Do not use ammonia-based cleaning solutions
because the ammonia destroys the plastic coating.
To remove light scratches on the smooth side only, use
a buffing compound such as, car wax. Lightly buff the
acrylic sheet using a clean buffer until the scratches
disappear.

Precor FTS Glide Specifications

Weight and Dimensions

length	48.5 inches (123 cm)
height	85 inches (216 cm)
width	53 inches (135 cm)