General Safety and Maintenance Manual: Annual Maintenance 25
Annual Maintenance
Perform these tasks on an annual basis, as appropriate for your
equipment:
Weight Stack Annual Maintenance
Once a year, Precor recommends disassembling the weight stack to
clean and inspect it thoroughly.
• Carefully remove the cable and guide rods from the weight stack.
Completely disassemble the weight stack in a well-ventilated area,
away from the exercise floor.
• Inspect weight plates and clean them thoroughly. Cracked or
broken plates should be replaced immediately (refer to Obtaining
Service to purchase replacements). Clean each plate individually
and inspect guide bushings.
• Inspect the bushings of the top weight plate and each individual
weight plate and replace a plate if it is excessively worn or broken.
• Clean the selector stem and inspect it for wear and damage.
• Reassemble the weight stack.
• Wipe down the weight stack enclosures (shrouds) with a damp
cloth as needed. Inspect all fasteners to ensure the shroud is
securely mounted.
Important: Precor recommends that you replace worn and damaged
cables during routine maintenance. It is recommended that all cables
be replaced annually.
To Next Page
Loading...
