Precor P30 Console Operating And Maintaining

Maintenance 67
To review and reset the status of the treadmill:
1. At the Welcome banner, press the Pause key, then enter
the following digits on the keypad:
5 1 7 6 5 7 6 1
2. Use the up and down arrow keys to scroll through the
menu names until HARDWARE VALIDATION appears,
then press OK.
3. In the Hardware Validation menu, use the up and down
arrow keys to scroll through the menu options until
ACTIVE STATUS LIGHT appears, then press OK again.
4. Press and hold the Quick Start key until the status light
returns to a steady blue color.
5. Press the Pause key to return to the Welcome banner.
Note: If the status light is steady yellow, you can also clear it
by reviewing and clearing the entries in the event log (refer to
Event Log).
To adjust the brightness of the status light:
1. At the Welcome banner, press the Pause key, then enter
the following digits on the keypad:
5 1 7 6 5 7 6 1
2. Use the up and down arrow keys to scroll through the
menu names until HARDWARE VALIDATION appears,
then press OK.
3. In the Hardware Validation menu, use the up and down
arrow keys to scroll through the menu options until AS
LIGHT BRIGHTNESS appears, then press OK again.
4. Scroll through the available settings (LOW, MED, and
HIGH) to select the brightness level you want, then press
OK.

Precor P30 Console Specifications

General

Brand	Precor
Model	P30 Console
Category	Music Mixer
Language	English