Setting Club Parameter Values
Use this information to customize the equipment for your setting.
Safety Code (Treadmill only)
Value Range: Enabled or Disabled
Default: Disabled
When the equipment is shipped from the factory, the safety code feature is disabled. An enabled safety code requires users to enter the
code
to use the equipment.
Select Language (All Equipment)
Value Range: English, Deutsch (German), Espanol (Spanish), Francais (French), Nederlands (Dutch), Portugues (Portuguese), Русский
(Russian), Italiano (Italian), and ニホンゴ (Japanese).
Default: English
Select your preferred language for the console display. Programming prompts are not affected by language selection. The prompts in
this section continue to appear in English. Set Units (All Equipment)
Set Units (All Equipment)
Value Range: U.S. or Metric
Default: U.S.
The equipment can display measurements in either Metric or U.S. Standard.
Important
If you change the Unit of Measure on a treadmill, be sure to check the speed setting to verify that it is correct.
Set Max Workout Time (All Equipment)
Value Range: 1 to 240 minutes (or No Limit)
Default: 60 minutes
You can set a maximum workout time per session. Choose a time limit between 1 and 240 minutes, or select No Limit if you do not want
to set a time limit. For example, if you set the time limit to 20 minutes, users can only enter a workout time between 1 and 20 minutes.
Note
The Military Performance Programs will not complete if the maximum exercise time limit is less than 40 minutes. Set the
maximum time to at least 40 minutes if you have enabled these performance programs.
Set Max Pause Time (All Equipment)
Value Range: 1 to 120 seconds
Default: 120 seconds
This setting limits how long equipment remains paused during a workout before it resets to the Welcome banner.
The optional power adapter must be connected on self-powered equipment to establish a definitive pause time limit. If the optional
power adapter is not attached and the rate of motion drops below the minimum requirements, the equipment begins its 30-second
shutdown, eliminating pause mode.
To Next Page
Loading...
Need help?
General
