Set Cool Down Time (All Equipment)
Value Range: 0 to 5 minutes
Default: 5 minutes
Select the maximum amount of time the equipment remains in the cool down mode, which is the period of time following the completion
of a program when the user exercises at a reduced work rate.
Set Metric Default (Treadmill only)
Value Range: Off or On
Default value: Off
This setting sets the console defaults for the following workout parameters:
• Metric Defaults on or off • Average Speed • Target HR
• Percent Complete • Cal/minute • Average HR
• Time in Zone • Cal/hour • Elevation gain
• Segment Time • WATTS • Pace
• Remaining • METS • Show all
Set Speed Limit (Treadmill only)
Values 800 Line Treadmill 700 Line Treadmill
Value Range
0.5–16 mph (0.8–25.4 kph) 0.5–12 mph (0.8–20 kph)
Default
12 mph (20 kph) 12 mph (20 kph)
Set the maximum speed that a user can enter when using the treadmill.
The speed is displayed in miles per hour (mph) or kilometers per hour (kph) depending upon the units of measure (U.S. Standard or
Metric) selected earlier.
Set Incline Limit (Treadmill only)
Value Range: Max 15
Default value: 15
Set the maximum percent incline that a user can enter when using the equipment.
Hidden Programs (Treadmill and EFX only)
Value Range: Show Programs or Hide Programs
Default: Hide Programs
When set to Show Programs, all Performance Programs are available to a user through the PERFORMANCE key. These programs
include: Gerkin Fitness Test, USAF PRT, NAVY PRT, ARMY PFT, USMC PFT, and Federal Law Enforcement PEB. Remember to set
Maxi Workout Time to at least 40 minutes to enable the Military Performance Programs.
If set to HIDE PROGRAMS, when the user presses PERFORMANCE, the message WORKOUT NOT AVAILABLE will scroll in the
upper text display.
To Next Page
Loading...
Need help?
General
