Mait (Maintenance) Configuration (EFX and Treadmill only)
Value Range: On or Off
Default: On
Turns on the service light counter and enables the Active Status Light™ (ASL) to alert your staff to the operating status of the
equipment.
The counter begins at 1000 miles for treadmills and 250 hours for the EFX, and counts down with use. When it reaches zero, the ASL
turns blue and blinks, alerting you that equipment maintenance is required.
Once maintenance has been completed, press and hold the Quick Start key to reset the counter.
Set Resistance Range (Bike only)
Value Range: High, Medium, or Low
Default: High
You can set a low, medium, or high base resistance on the recumbent or upright bikes. There are 25 levels of resistance within each
base setting, but the base setting affects the overall resistance range. The following ranges are available:
High: Provides full resistance range.
Medium: Provides approximately two thirds of the resistance that is available within the high group setting.
Low: Provides approximately one third of the resistance that is available within the high group setting.
Set Crossramp Auto Level (EFX Dual only)
Value Range: 0 to 20
Default: 10
Use this setting to choose a specific ramp incline so that the EFX automatically returns to that incline at the end of a workout.
To Next Page
Loading...
Need help?
General
