Setting Up the Console 33
Event
Number
Description of Event
78 Belt replacement warning (AMT only)
79 Belt replacement required (AMT only)
80 Phase A or B missing (incline control; treadmill only)
81 Phase C missing (incline control; treadmill only)
82 Phase A or B missing (speed control; treadmill only)
83 Phase C missing (speed control; treadmill only)
85 No dynamic break resistor detected, or dynamic break
resistor is detected as an open circuit, at startup time
(treadmill only)
86 Old console detected on new equipment (treadmill
only)
87 New console installed on older equipment (treadmill
only)
88 Motor temperature too high (treadmill only)
To Next Page
Loading...
