Precor P31 - Setup Menu Settings; Menu Language Configuration; OSD Time Out Settings; Closed Caption Configuration

View the Setup Menu Settings
This menu contains the following presets:
• Menu Language
• OSD Time Out
• Closed Caption
• Restore Default
• Headphone Detect
• USB Update
• Software Version
Grayed out settings are not available.
Table 2. Picture Menu
Setting
Value
Default
Menu Language English, French, Spanish English
OSD Time Out 5, 15, 30, 45, 60 sec 30
Closed Caption Basic Off
- Basic CC1 Off, CC1, CC2, CC3, CC4, Text1, Text2, Text3, Text4 mode CC1
- Advanced Service1 Off, Service1, Service2, Service3, Service4, Service5, Service6 mode Service1
Restore Default Restores all settings to factory default settings N/A
Headphone Detect Enabled, Disabled Disabled
USB Update Use to update software (see procedure below) N/A
Software Version For example: 303751-xxx xxx N/A
USB Update
Use this setting to update software for your PVS.
Important Perform the following procedure in the order presented.
To perform a USB Update:
1. Turn on the PVS.
2. Insert the USB flash drive before entering the Setup Menu.
3. In the Setup Menu, select USB Update
.
4. Select F/W File, then press CC.
Note If USB is not properly inserted, the message, No Device, displays in the top left corner of the screen.
5. Select the USB drive, then press CC. After upload is completed (approximately 30 seconds), the TV turns off.
Important Do not turn off the TV power or remove USB flash drive during the USB update.
6. Remove the USB flash drive.
7