Connect to other devices
Use the following information to connect ANT+™ and Bluetooth® compatible devices to the console.
ANT+™
Heartrate display
• User heartrate detection is only available with ANT+ compatible sensors displaying the ANT+™ icon.
• The console detects the closest sensor and displays the 4-digit ID number. If you know your 4-digit ID, check to make sure
it is the ID that pairs with the console.
• When your workout ends, your information is not saved on the console.
Data transmission:
• A device must be compatible with the ANT+ FE-C standard (displaying this icon ) in order to function properly.
• To pair to the console, set your device to the bike number based on your bike’s serial number or the number created using
the service modes DEVICE ID.
• The console can pair to a club’s group leaderboard.
• The console can send and display data to multiple devices.
Bluetooth®
• Your devices may be used to receive data from the console provided the application is compatible with the product
• The console pairs to one user device at a time.
• When pairing, the console displays, ‘‘XXXX,’’ where XXXX is the bike’s serial number or the number created using the service
modes DEVICE ID. The words, “CHRONO XXXX” display on the mobile device that is attempting to pair with the console.
• When your workout ends, your information is not saved to the console.
• Bluetooth® heart rate sensors are not compatible with this console.
8
To Next Page
Loading...
Need help?
General
