18 Assembling and Maintaining the StretchTrainer
6. Slide the other level adjuster onto the opposite base rail.
7. Carefully lower the equipment onto the floor. Avoid
pinching your fingers.
Important: If the equipment is placed on a slightly, uneven
surface, rotating the rear level adjusters can help, but will not
compensate for extremely uneven surfaces. The maximum
height that you can compensate for using the rear level
adjusters is about
¹₄
inch (6 mm).
8. To level the equipment, sit on the StretchTrainer. If it
wobbles slightly, rotate the rear level adjusters until the
equipment is stable.
Figure 15: Rear level adjuster
9. Use a cloth dampened with a non-abrasive degreaser to
clean any parts of the equipment that have been
blackened by grease from the bolts.
Important: Do not discard the hex wrenches supplied with the
equipment. Maintain the integrity of the StretchTrainer by
occasionally checking and tightening the hardware. Use the hex
wrenches to tighten any bolts that become loose.
To Next Page
Loading...
Need help?
General
