Assembling the StretchTrainer 17
2. Fully tighten all seat bracket bolts.
Important: Do not overtighten the bolts. Doing so may
compress or crack the plastic alignment bracket.
3. Remove the paper backing from the adhesive tape on the
placard mount.
Figure 13: Adhesive tape removal
4. Carefully center the instructional placard on the placard
mount and press firmly into place.
Figure 14: Placard attachment
5. To attach the rear level adjusters, raise the rear end of the
StretchTrainer slightly off the floor. Slide a rubber level
adjuster onto one side of the rear base rail.
To Next Page
Loading...
