Page 9
For technical questions, please call 1-888-866-5797.
ITEM 62523
SAFETYOPERATIONMAINTENANCE SETUP
Starting the Engine
Before Starting the Engine
a. Inspect the generator and engine.
b. Disconnect all electrical loads from the generator.
c. Fill the engine with the proper amount and type of
both stabilizer-treated unleaded gasoline and oil.
Manual Start
1. Open vent on Gas Cap.
2. Move the Economy (ESC) Switch
to the OFF position.
3. Turn the Combination Switch
to the START position.
4. Grip the Starter Handle of the Engine loosely and
pull it slowly several times to allow the gasoline to
flow into the Engine’s carburetor. Then pull the Starter
Handle gently until resistance is felt.
Allow Cable to retract fully and then pull it
quickly. Repeat until the Engine starts.
Note: Do not let the Starter Handle snap back against the housing.
Hold it as it recoils so it doesn't hit the housing.
Note: If engine does not start, check engine oil level.
Engine will not start with low or no engine oil.
OFF
RUN
START
LOW OIL
OVERLOAD
OUTpUT
pARALLEL OUTLETS
RESET
AC 120V
RESET
DC 12V
ESC
THROTTLE
1
OFF
RUN
START
LOW OIL
OVERLOAD
OUTpUT
pARALLEL OUTLETS
RESET
AC 120V
RESET
DC 12V
ESC
THROTTLE
2
To Next Page
Loading...
Need help?
General
