16
www.pregis.com 38-OM225-1
1. Press and hold all three of the pre-
set buttons (a, b & c).
2. After 5 seconds a ’dot’ will appear
below the right hand digit of the
length display.
Instructions for Use
The three preset buttons can be set to produce the programmed values instantly when
the preset button is pressed and released by the operator.
Programming the Preset Buttons for ‘Instant’ Operation
When one of the preset buttons is pressed and released the programmed quantity and
length of packs will be produced instantly (without pressing the ‘Run’ button).
To change the preset button operation to require the ‘Run’ button to be pressed, press
and hold
all three
preset buttons for 5 seconds until the ‘dot’ disappears.
To Next Page
Loading...
