Prescitech X12 - WPS Setup Method

02
WPS - Method
You can also use the WPS function as an alternative
Set-up method, if you have a WPS button available on
your primary router. Hold the WPS button of your Prima-
ry Router/WiFi AP till the WPS LED starts blinking.
Press and hold the WPS 3 seconds on the Rear Panel.
Once WPS light starts blinking on it as well, please wait
for a minute for The primary router/AP and the Extender
Prescitech X12 to pair up and then connect to the
"Prescitech X12_2.4G_EXT or
Prescitech X12_5G_EXT" SSID in your Smart Phone
using your primary router's WIFI password.
6) Enter your Router's/AP's WIFI password in the Pass-
word/WIFI Key/Security key column and click on
"Apply"
7) Open the list of available networks again using your
smartphone. Find out the New SSID "Prescitech
X12_2.4G_EXT or Prescitech X12_5G_EXT" and con-
nect with it using the same password as of your primary
router/AP.
8) If the internet works, unplug Prescitech X12 and plug
it halfway between your Router and the Device intended
for the internet usage/dead zones in your home where
you were getting low to no WIFI signals.