Pressure Systems 9022 - Page 10

Pressure Systems, Inc. NetScanner™ System (9016, 9021, & 9022) User’s Manual
www.PressureSystems.com
- ix -
Table of Contents (Cont.)
5.1.6 Replacement of O-Rings ................................... 5-10
5.1.6.1 DH200 Pressure Transducer O-Ring Replacement ......... 5-11
5.1.6.2 Tubing Plate O-Ring Replacement ..................... 5-12
5.1.6.3 Adapter Plate O-Ring Replacement .....................5-13
5.1.6.4 Calibration Manifold Piston O-Ring Replacement ......... 5-14
5.1.6.5 Solenoid Valve O-Ring Replacement ................... 5-15
5.2 9022 Excitation Trim ............................................ 5-16
5.3 9022 Procedure for Changing the Excitation Jumper Setting (JB1) ........ 5-17
5.4 Upgrading Module Firmware ...................................... 5-17
5.2.1 Upgrading Firmware Via Host TCP/IP Port .................... 5-18
Chapter 6 — Troubleshooting Guide .....................................6-1
6.1 Ethernet Module Troubleshooting ................................... 6-1
6.1.1 Checking Module Power-up Sequence ......................... 6-1
6.1.2 Checking Module TCP/IP Communications ..................... 6-2
6.1.2.1 Module IP Address Assignment ........................ 6-2
6.1.2.2 Host IP Address Assignment for Windows 95/98/NT ........ 6-4
6.1.2.3 Verifying Host TCP/IP Communications ................. 6-4
6.2 Zero and Gain Calibration Troubleshooting ........................... 6-6
6.3 User Software ................................................... 6-7
Chapter 7 — Start-up Software ......................................... 7-1
7.1 Introduction .................................................... 7-1
Appendices
Appendix A: All Commands — Quick Reference
Appendix B: NetScanner System Response Error Codes
Appendix C: Cable Diagrams
Appendix D: Mounting Diagrams
Appendix E: NetScanner
™
System Range Codes
Appendix F: NetScanner
™
System/9000 Series Products
Appendix G: Binary Bit Map