Pressure Systems 9022 - Table of Contents

Pressure Systems, Inc. NetScanner™ System (9016, 9021, & 9022) User’s Manual
www.PressureSystems.com
- vi -
Table of Contents
Chapter 1 — General Information ....................................... 1-1
1.1 Introduction .................................................... 1-1
1.2 Description of Instruments ......................................... 1-3
1.3 Options ........................................................ 1-4
1.3.1 Pressure Ranges ........................................... 1-4
1.3.2 Manifolds and Pressure Connections ...........................1-4
1.3.3 Communications Interfaces .................................. 1-5
Chapter 2 — Installation and Set Up ..................................... 2-1
2.1 Unpacking and Inspection ......................................... 2-1
2.2 Safety Considerations ............................................ 2-1
2.3 Preparation for Use .............................................. 2-1
2.3.1 Environment .............................................. 2-1
2.3.2 Power ................................................... 2-2
2.3.3 Mounting and Module Dimensions ............................ 2-2
2.3.4 Network Communications Hookup ............................ 2-3
2.3.4.1 Ethernet Host Port Hookup ............................ 2-3
2.3.5 Diagnostic Port Hookup ..................................... 2-6
2.3.6 Pressure Connections ....................................... 2-6
2.3.6.1 RUN Mode Inputs ................................... 2-7
2.3.6.2 CAL Mode Inputs ................................... 2-8
2.3.6.3 Purge Mode Inputs ................................... 2-8
2.3.6.4 Leak Mode Inputs ................................... 2-8
2.3.6.5 Supply Air ......................................... 2-9
2.3.7 9021 and 9022 Transducer Installation ......................... 2-9
2.3.7.1 Installation of 9400, 9401, and 9402 Transducers .......... 2-10
2.3.7.2 Installation of All Other Transducers .................... 2-11
2.3.8 Case Grounding .......................................... 2-11
2.3.9 Trigger Input Signal ....................................... 2-12
2.3.10 Power Up Checks and Self-Diagnosis ......................... 2-12
Chapter 3 — Programming and Operation ............................... 3-1
3.1 Commands and Responses ......................................... 3-1
3.1.1 Introduction .............................................. 3-1
3.1.1.1 TCP/UDP/IP Protocols ............................... 3-1