Elite Traveller www.pridemobility.com 21
OFF-BOARD BATTERY CHARGER
The off-board battery charger, when plugged
into the charger power lead receptacle
(located on the battery pack) and a standard
electrical outlet, charges the Travel Scooter’s
batteries. See figure 9.
Figure 9. Off-Board Battery Charger
III. YOUR TRAVEL SCOOTER
Figure 10. Front Fender Panel
Figure 12. Side Panel
PUSH HOLE
Figure 13. Tiller Console Visor
Figure 11. Rear Fender Panel
PUSH HOLE
PLUGS INTO BATTERY PACK
PLUGS INTO STANDARD
ELECTRICAL OUTLET
SHROUD PANELS
You can change the colour of your Travel
Scooter by removing the coloured plas-
tic shroud panel pieces and replacing
them with one of the other supplied sets.
The panels are held in place by a hook
and loop reusable fastener.
To remove the shroud panel pieces:
1. Use your finger to locate the push hole
behind each shroud piece.
2. Push through the hole to separate the
piece from the Travel Scooter. See
figures 10, 11 and 12.
To remove the tiller console visor:
1. Gently pull the top of the visor to-
ward the rear of the Travel Scooter
to loosen it from the reusable fas-
tener, then gently pull the sides of the
visor away from the tiller console and
lift. See figure 13.
NOTE: The front fender shroud is
removed in the same fashion as the
tiller console visor.
To reinstall the shroud pieces, place
each piece in its appropriate location and
push with slight pressure to secure the
reusable fastener.
NOTE: When installing the front
fender panel, make sure the tab at the
bottom of the panel is inserted into
the tab opening before securing the
panel. See figure 10.
TAB
LED’S
To Next Page
Loading...
