EasyManuals Logo

Pride Mobility Go-Go Elite traveller User Manual

Pride Mobility Go-Go Elite traveller
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Elite Traveller www.pridemobility.com 9
II. SAFETY
Perform the following inspections prior to using your Travel Scooter:
! Check for proper tyre inflation (if equipped with pneumatic tyres).
! Check all electrical connections. Make sure they are tight and not corroded.
! Check all harness connections. Make sure they are secured properly.
! Check the brakes.
! Check battery charge.
If you discover a problem, contact your authorised Pride Provider for assistance.
TYRE INFLATION
If your scooter is equipped with pneumatic tyres, you should check or have the air pressure checked at least once a
week. Proper inflation pressures will prolong the life of your tyres and help ensure the smooth operation of your scooter.
WARNING! It is critically important that the psi/bar/kPa air pressure indicated on each tyre
be maintained in pneumatic tyres at all times. Do not underinflate or overinflate your tyres.
Low pressure may result in loss of control, and overinflated tyres may burst. Failure to
maintain the psi/bar/kPa air pressure raiting indicated on pneumatic tyres at all times may
result in tyre and/or wheel failure.
WARNING! Inflate your Travel Scooter tyres from a regulated air source with an available
pressure gauge. Inflating your tyres from an unregulated air source could overinflate them,
resulting in a burst tyre.
WARNING! When changing a tyre, remove only the centre lug nut, then remove the wheel.
If any further disassembly is required, deflate the tyre completely or it may explode.
NOTE: If tyres on your Travel Scooter list the psi raiting only, use the following conversion formulas to
find the bar or kPa rating: bar=psi x 0.06895, kPa= psi x 6.89476.
WEIGHT LIMITATIONS
Your Travel Scooter is rated for a maximum weight capacity. Refer to the specifications table for information.
MANDATORY! Stay within the specified weight capacity of your Travel Scooter. Exceeding
the weight capacity voids the warranty. Pride will not be held responsible for injuries and/
or property damage resulting from failure to observe weight limitations.
WARNING! Do not carry passengers on your Travel Scooter. Carrying passengers on your
Travel Scooter may affect the centre of gravity, resulting in a tip or a fall.
INCLINE INFORMATION
More and more buildings have ramps with specified degrees of inclination, designed for easy and safe access.
Some ramps may have turning switchbacks (180-degree turns) that require you to have good cornering skills on
your Travel Scooter.
! Proceed with extreme caution as you approach the downgrade of a ramp or other incline.
! Take wide swings with your Travel Scooter around any tight corners. If you do that, the Travel Scooters rear
wheels will follow a wide arc, not cut the corner short and not bump into or get hung up on any railing corners.
! When driving down a ramp, keep the Travel Scooter’s speed adjustment set to the slowest speed setting to
ensure a safely controlled descent.
! Avoid sudden stops and starts.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pride Mobility Go-Go Elite traveller and is the answer not in the manual?

Pride Mobility Go-Go Elite traveller Specifications

General IconGeneral
Weight Capacity300 lbs
Maximum Speed4 mph
Ground Clearance2.5 inches
Turning Radius33 inches
Overall Width19.5 inches
TiresFront: 2 inches x 8 inches, Rear: 2.5 inches x 8 inches
ChargerOff-board, 2 amp
Seat Width17 inches
Seat Depth16 inches
Battery TypeSealed Lead Acid
Weight (with batteries)96 lbs
Seat Height20 inches

Related product manuals