Elite Traveller www.pridemobility.com 31
VII. DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
You can disassemble the Travel Scooter into five pieces:
the seat, the front section, the rear section, the basket
and the battery pack. See figure 21. No tools are
required to disassemble or assemble your Travel
Scooter. Always disassemble or assemble your Travel
Scooter on a level, dry surface with sufficient room for
you to work and move around—about 1.5 metres (five
feet) in all directions. Remember that some Travel
Scooter components are heavy and you may need as-
sistance when lifting them.
WARNING! Travel Scooter
components are heavy. Avoid
lifting beyond your capability and
ask for assistance when necessary
while disassembling or assembling
your Travel Scooter.
SEAT
REAR SECTION BATTERY PACK
BASKET
FRONT SECTION
Figure 21. Disassembled Travel Scooter
1. Lock the tiller in the straight ahead position by pushing the tiller lock knob in and turning it clockwise 90°. See
figure 22. The front wheel must face forward in order to lock the tiller.
2. Remove the seat by lifting it straight up and off of the Travel Scooter. If you encounter resistance when
removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up on the
seat.
3. Remove the battery pack from the Travel Scooter.
Figure 22.
Tiller Lock knob (Locked)
LOCKED
POSITION
Figure 23. Tiller Lock Knob (Unlocked)
UNLOCKED
POSITION
Frame Separation
1. Lower the tiller and tighten the tiller adjustment knob.
2. Lift up on the frame release lever until the frame hooks are no longer resting on the lower frame tube.
3. Slowly separate the two sections of the Travel Scooter. See figure 24.
To Next Page
Loading...
