Table 2. J6 with NE+ Electronics Error Codes
LCD DISPLAY DIAGNOSIS SOLUTION
Power Section Error Cycle power. Check power module (2) and
NE+ joystick module (1) connections and
wiring. See Section 3. Contact Quantum
Technical Service for further troubleshooting.
Joystick Not Centered Release joystick and make sure the joystick is
in the center position. Power off and on again.
Check connections. See Section 3. Contact
Quantum Technical Service for further trou-
bleshooting.
Communications Error
Check joystick module cable connections.
See Section 3.
Motor/Brake Error
Check motor/brake connectors.
See Section 3
.
Low Battery Voltage Charge batteries.
High Battery Voltage
Disconnect charger. See Section 3. Contact
Quantum Technical Service for further trou-
bleshooting.
Drive Thermal Warning
Allow motors to cool. See Section 3. Contact
Quantum Technical Service for further trou-
bleshooting.
Open Motor Error Check motor connectors. See Section 3.
Speed Limit Warning Return seat to normal or upright position. See
Section 3. Contact Quantum Technical Ser-
vice for further troubleshooting.
Low Battery Recharge batteries.
To Next Page
Loading...
