Table 2. J6 with NE+ Electronics Error Codes (Continued)
LCD DISPLAY DIAGNOSIS SOLUTION
Idle Mode Cycle power. See Section 3. If the problem
continues, contact Quantum Technical Ser-
vice for further troubleshooting.
Attendant Control Error Check Attendant Control connections and
wiring. See Section 3. Contact Quantum
Technical Service for further troubleshooting.
Battery Charging or Drive
Inhibit - Joystick Powered
On
Unplug charger when charging is complete.
Check connections.
See Section 3
.
Battery Charging or Drive
Inhibit - Joystick Powered
Off
Unplug charger when charging is complete.
Check connections.
See Section 3
.
System Lock Mode. The NE+ controller is locked out and must be
unlocked. See Section 2.
Drive Inhibit
Check power module connections. See Sec-
tion 3.
To Next Page
Loading...
