2
DEALER PREPARATION CHECK LIST
ROTARY MOWERS
The following checklist should be completed using
this Operator Manual for reference.
___ Three-Point A-Frame Assembled
___ Check Fluid levels in Gearbox.
___ All fittings are lubricated.
___ All shields are secured and in good condition.
___ All fasteners are secured.
___ Mower condition should be new (i.e. paint, welds)
___ Operator Manual has been delivered to Owner
___ Provided instructions on safe and proper use of
the implement.
___ Modification Notice—unauthorized alteration voids
the warranty.
____ RMS GEARBOX has a driveline snap
ring already installed. The snap ring prevents the driveline
from swinging if the shear pin breaks while in operation.
• If the driveline is not connected to the gearbox, remove
the snap ring before connecting the Driveline to the gear-
box and immediately replace to secure the driveline.
• If the driveline is already installed, verify that the
snap ring is present!
Failure to use the snap ring may cause
serious injury or death!
WARNING
OSHA, ASABE, SAE and ANSI standards require the use of Chain Guards or other protective
guards at all times for non-agricultural use. Priefert Manufacturing strongly recommends that
such guards should be used for Agricultural uses as well, to minimize risk of property damage,
serious bodily injury or even death from thrown object hazards or by contacting rotating parts, i.e.
driveline, implement blades.
Dealer’s Signature ______________________________________________
Purchaser’s Signature ______________________________________________
Model Number: ______________________________________________
Serial Number: ______________________________________________
(Serial Number Plate location is shown on page 9)
Do not remove this checklist from the Operator’s Manual.
It is the responsibility of the dealer to complete the procedures listed above
before delivery of this implement to the buyer.
Snap Ring
To Next Page
Loading...
