CD21 COMPACT DISC PLAYER USER GUIDE
This chapter introduces the back panel connections and the front
panel controls of the CD21 Compact Disc Player.
: Before connecting power check
that the required supply voltage, indicated on
the back panel, cor re sponds to your local AC
supply. If a different voltage is stated on the
type plate do not connect the CD21 to the mains power,
and seek advice from your dealer.
Connect the mains power using the enclosed mains cable.
in the system from the mains power before connecting or
disconnecting any of the cables. Failure to do this might
seriously damage the unit.
To prevent re or shock hazard, do not expose this
appliance to dripping or splashing. No objects lled with
liquids, such as vases, should be placed on the CD21.
If you want to build in the CD21 you need to be sure to
allow space of at least 20 cm behind, 10 cm on both sides
and 30 cm above the top panel of the unit. This is to pre-
vent re or damage caused by overheating. Also make sure
that the main switch is accessable.
Use the main switch on the back panel (D).
During normal operation you can leave the CD21
switched on and in standby mode.
To switch on from standby or to standby
Pressing on the front panel or on the remote control,
will change the standby mode.
Pressing on the front panel or on the remote control,
To Next Page
Loading...
