Install Smart-Sync™ Bridge
A Smart-Sync Bridge can be installed either by a surface or wall-mount method. The mounting
method is commonly dependent on its installation location area. Both techniques can be used
together if desired.
Note:
Wi-Fi or Non-DCHP Ethernet network only - a Smart-Sync Bridge is required to be configured
with your OneVue account ID and Wi-Fi or Non-DHCP network settings before it's installed at
its permanent installation location. Verify the device can successfully check-in to your OneVue
account at its installation location. For more information, see "Check-In to OneVue" on the
previous page.
To Next Page
Loading...